Arthur_Martin AGT6242NVK Manual de usuario descargar pdf (Pagina 7)

• Disconnect the appliance from the

mains supply.

• Cut off the mains electrical cable close

to the appliance and dispose of it.

• Flat the external gas pipes.

INSTALLATION

WARNING! Refer to Safety

chapters.

Before the installation

Before you install the hob, write down the

information bellow from the rating plate.

The rating plate is on the bottom of the

hob.

Model .......................................

PNC .........................................

Serial number ...........................

Gas Connection

WARNING! The following

instructions about installation,

connection and maintenance

must be carried out by qualified

personnel in compliance with

standards and local regulations

in force.

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with

the regulation in force. If you use flexible

metallic pipes, be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

Make sure that the gas supply

pressure of the appliance

obeys the recommended

values. The adjustable

connection is fixed to the

comprehensive ramp by means

of a threaded nut G 1/2". Screw

the parts without force, adjust

the connection in the

necessary direction and tighten

everything.

A B C

A. End of shaft with nut

B. Washer supplied with the appliance

C. Elbow supplied with the appliance

WARNING! It is important to

install the elbow correctly.

Make sure that the shoulder is

on the end of the thread. Then

install it on the hob connecting

pipe. Incorrect assembly may

cause a gas leakage.

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue

with the gas connection.

The flexible pipe is prepared for apply

when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting

edges or corners;

• it can be easily examined in order to

make sure its condition.

The control of preservation of the flexible

pipe consists in checking that:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

• the material is not hardened, but shows

its correct elasticity;

7

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comentarios a estos manuales

Sin comentarios