Arthur_Martin AKG633A7OX Manual de usuario descargar pdf (Pagina 23)

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING! When installation

is complete, make sure that the

seal of each pipe fitting does

not leak. To check the seal use

a soap solution, not a flame.

The gas supply ramp is on the rear side of

the control panel.

WARNING! Before you

connect the gas, disconnect

the appliance from the

electricity supply or switch off

the fuse in the fuse box. Close

the primary valve of the gas

supply.

Adjustment to different types of

gas

WARNING! Let only an

authorized person do the

adjustment to different types of

gas.

If the appliance is set for liquid

gas you can change it to

natural gas, with the correct

injectors.

The gas rate is adjusted to suit.

WARNING! Before you replace

the injectors, make sure that

the gas knobs are in the Off

position. Disconnect the

appliance from the electrical

supply. Let the appliance cool

down. There is a risk of injury.

The appliance is set to default

gas. To change the setting

choose a pipe holder from the

list. Always use the gasket

sealing.

A CB

A. Gas connection end

B. Natural Gas pipe holder

C. LPG pipe holder

Hob injectors replacement

Replace the injectors when you change

the gas type.

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. Remove the injectors with a socket

spanner 7.

4. Replace injectors with the ones

necessary for the type of gas you use.

5. Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply.

You can find this plate in

the bag supplied with the

appliance.

If the supply gas pressure is not constant

or it is different from the necessary

pressure, install an applicable pressure

adjuster on the gas supply pipe.

23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios