Arthur_Martin AKG601A1OW Manual de usuario descargar pdf (Pagina 9)

WARNING! Be very careful

when you use open fire in the

kitchen environment. The

manufacturer declines any

responsibility in case of the

flame misuse.

The spark generator can start

automatically when you switch

on the mains, after installation

or a power cut. It is normal.

In the absence of electricity you

can ignite the burner manually.

Ignition of a hob burner with the

thermocouple

• For manual ignition put the flame near

the burner. Push the knob for the hob

down and turn it counterclockwise to

the maximum gas flow position .

• For ignition with spark generator button

push and hold the spark generator

button . At the same time push the

knob for the hob down and turn it

counterclockwise to the maximum gas

flow position . Release the spark

generator button when burner lights.

Keep the knob for the hob pushed for

equal or less than 10 seconds to let the

thermocouple warm up. If not, the gas

supply is interrupted.

Adjust the flame after it is regular.

WARNING! Do not keep the

knob pushed for more than 15

seconds. If the burner does not

light after 15 seconds, release

the knob, turn it into the off

position and try to light the

burner again after minimum 1

minute.

If after some tries the burner

does not light, check if the

crown and its cap are in the

correct position.

If the burner accidentally goes

out, turn the knob to the off

position and try to light the

burner again after minimum 1

minute.

Burner overview

A

B

D

C

A. Burner cap

B. Burner crown

C. Ignition candle

D. Thermocouple (if applicable)

Turning the burner off

To put the flame out, turn the knob to the

off position

.

WARNING! Always turn the

flame down or switch it off

before you remove the pans

from the burner.

HOB - HINTS AND TIPS

WARNING! Refer to Safety

chapters.

Cookware

WARNING! Do not put the

same pan on two burners.

9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comentarios a estos manuales

Sin comentarios